Airace One

Airace One

Installation Instructions

1. Open Google Play Store on your Android Smartphone and search for “Airace One”.
2. Click on the top result and click Install to install the application on your smartphone.
3. Here is a direct play store link: Airace One

System Requirements

• Operating System: Android Oreo (8.0) or higher
• RAM: 2GB or more for optimal performance
• Internet Connection: Stable and active
• Wifi/Bluetooth Connection
• Screen size: 6.0 inch or higher

How to Use

1. On opening the Airace One Mobile App for the first time, you will be required to give Bluetooth and Location permission to the app which is required for proper functioning of the app.
2. It will ask you to log in to your Airace One account using your phone number and OTP. By logging in, you can have access to an online saved device and online survey project. You can also tap on ‘Skip Login’ to proceed without login
3. The App has three main tabs to navigate to viz-a-viz, Devices, Survey, and Settings and a top status bar where we can see if any device is connected, NTRIP connection, No. of satellites visible etc. as shown in the screenshot below.

Manage Device Configuration

In the Devices tab, you can efficiently manage and configure your devices. This includes:

• Connecting to Airace GNSS Devices: Pair and connect to your Airace GNSS devices via Bluetooth.
• Mode Selection: Switch between Base and Rover modes as needed.
• Configuration Settings: Set up and adjust Rover and Base configurations.
• Radio Setup: Configure radio settings for optimal performance.
• Message Logging: Enable or disable message logging as required.
• IMU Management: Turn the IMU (Inertial Measurement Unit) on or off.
• Reset to Default: Restore device settings to their default configuration.

This comprehensive management functionality ensures that you can tailor your device settings to meet your specific requirements.

Connecting to Airace Rover/Base via Bluetooth

1. In the Devices tab, click on Device Connection and check if your Airace rover/base is listed. If it is not listed, first pair your device with your mobile device via Bluetooth, and then click Refresh.
2. Once your device appears in the list, click the Connect button to initiate the connection.
3. After a successful connection, the Connect button will show as Disconnect button.
4. To disconnect a device click onDisconnect button.

Switching Base/Rover Mode

1. After establishing a successful Bluetooth connection, you can switch between Rover and Base modes.
2. Click on the Switch Rover/Base button, then select either Switch to Base Mode or Switch to Rover Mode on the subsequent screen.

Configure Rover

1. Click on the Configure Rover button to access Rover configuration settings.
2. You can adjust the measurement rate (in Hz or seconds), modify the dynamic model, select the satellite constellation, and set the minimum satellite signal threshold, among other options.

Configure Base

1. Click on the Configure Base button to enter Base configuration mode.
2. You can toggle Base mode, set the minimum observation time, adjust the mean 3D standard deviation in meters, view the Base value, and enable long-range radio, among other settings.

Configure Logging

1. To configure logging, click on the Logging button.
2. You can choose to log data to an SD card and set parameters for maximum log time and maximum log length.

Messages

Click on the Messages button, then select the Reset to PPK/RTK Logging Defaults option on the following screen to restore logging settings to their default state.

Configure Wi-Fi

1. Click on the Configure Wi-Fi button to enter Wi-Fi credentials.
2. Provide the SSID and password to set up the Wi-Fi connection.

Configure Radio

Click on the Radio Setup button to configure the Radio Port Baud Rate and Data Port Baud Rate.

Enable/Disable IMU

Click on the Enable IMU button to activate the IMU. Once enabled, the button will change to Disable IMU. Click on it to deactivate the IMU.

Reset to Defaults

Click on the Reset to Default button to revert all configuration settings to their default values.